1987-2016 Kawasaki KLR650 Pannier Mounting Rack
Click To Enlarge


Pannier mounting rack for Kawasaki KLR650 dual sport motorcycles. Mount your own ammo can, Pelican case, aluminum panniers or any luggage with this rack. Made of 3/4 inch steel tube construction, powder coated finish.  Brackets included to mount your own case.

 Easy bolt-on installation. We supply all the bolts needed to secure these pannier racks also bolts to install your own ammo can, Pelican case or aluminum panniers!


Powder coated finish

Made from 3/4 inch steel tubing

Easy bolt on installation

Turn signal does not need to be relocated

Fits both the old klr 1987-2007 and new klr 2008-2016

Comes with the mounting brackets and bolts to mount your own case










Pannier installation

1,remove the 2 side bolts that hold the rear cargo rack.remove the 2 upper bolts from the passenger footpeg bracket.

2,hold the pannier rack in place and install the 2 bolts that came with the rack ,the longer bolt goes to the rear rack and the shorter to the footpeg bracket,install both sides and the rear cross bar,remember not to tighten any bolts until you have all of them installed,then you can tighten them.you will need a 13 mm socket.

3,hold up your case to the pannier frame,exactly where you want to mount it,and with a black felt pen outline the frame on the back of your case,it helps if you have somebody helping you with this,do both sides.

4,remove the pannier frame from the bike.

5,place your cases face down and put the pannier frame on them where you outlined them with the pen.put the cases side by side so you can see if both sides look about the same.

6,put the brackets in place,mark the holes with a pen,and drill them.

7,bolt on the brackets.12x 6mm bolts and washers with nuts,you will need a 10 mm socket and wrench.

8,place the pannier frames on the back of the cases,slide them inside the brackets,you will have to drill 2 more holes for the T bolts.use a small drill to drill the holes thru the welded nuts,make sure you do not damage the thread inside the nuts,then remove the frame and drill the holes with a bigger drill so the T bolts will fit thru easily.these T bolts will secure your case to the frame from the inside of your case.

9,bolt on the pannier frame and hang the cases on the frame,install the T bolts from the inside of your case,tighten the bolts with your hand ,do not use any tool to tighten these bolts.

See more pictures at www.dualpurposebikes.com

  • Item #: 0001

1987-2016 Kawasaki KLR650 Pannier Mounting Rack

Price: $169.00
* Marked fields are required.
Qty: *
Reviews (0) Write a Review
No Reviews. Write a Review